DS EN ISO 294-5:2013被替代
Plastics - Injection Moulding Of Test Specimens Of Thermoplastic Materials - Part 5: Preparation Of Standard Specimens For Investigating Anisotropy
出版：Danish Standards
專家解讀視頻
基本信息
標準編號： DS EN ISO 294-5:2013
發布時間：2013/3/2 0:00:00
標準類別：Standard
出版單位：Danish Standards
標準頁數：24
標準簡介
Defines a two-cavity mould (designated the type F ISO mould) for the injection moulding of 80 mm x 90 mm plates with a preferred thickness of 2 mm for single-point data acquisition because 2 mm has been found to provide the maximum anisotropic properties, with only a slight sensitivity to the rate of injection.
替代本標準的新標準
