IEC 60068-2-30:2005 Determines the suitability of components, equipment or other articles for use, transportation and storage under conditions of high humidity - combined with cyclic temperature changes and, in general, producing condensation on the surface of the specimen. If the test is being used to verify the performance of a specimen whilst it is being transported or stored in packaging then the packaging will normally be fitted when the test conditions are being applied. For small, low mass specimens, it may be difficult to produce condensation on the surface of the specimen using this procedure; users should consider the use of an alternative procedure such as that given to IEC 60068-2-38. The main changes with respect to the previous edition are listed below: - editorial changes, - addition of normative references, - addition of guidance for temperature tolerances, - period for recovery has been extended. It has the status of a horizontal standard in accordance with IEC Guide 104.

IEC 60068-2-30 Ed. 2.0

DIN IEC 60068-2-30 (1986-09) - Identical

NBN C 83 160:1984 - Identical

SN EN 60068-2-30:2005 - Identical

HD 323.2.30:1987 - Identical

BS 2011-2.1Db:1981 - Identical

NFC 20 730:1987 - Identical

UNE EN 60068-2-30:2006 - Identical

UNE 20501-2-30:1994 - Identical

NBN C 83 100:1984 - Identical

SS EN 60068-2-30 Ed. 2 (2006) - Identical

I.S. EN 60068-2-30:2005 - Identical

SS EN 60068 Ed. 3 (2000) - Identical

OVE/ONORM EN 60068-2-30:2006 - Identical

CEI EN 60068-2-30 Ed. 2 (2006) - Identical

AS 1099.2Db-1982 - Equivalent

SEN 43 16 04:1971 - Similar

NBN C 83 300:1985 - Identical

BS EN 60068-2-30:2005 - Identical

DIN EN 60068-2-30 (2006-06) - Identical

NBR IEC 60068-2-30:2006 - Identical

NF EN 60068 2-30:2006 - Identical

PN EN 60068-2-30:2006 - Identical

NEN EN IEC 60068-2-30:2006 - Identical

PN EN 60068-2-30:2008 - Identical